Double Shower Curtain Rod Installation Instructions

In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home.

Double shower curtain rod installation instructions.

Rotate the wall plate until it fits flush with the end of the rod. Then install the rod and place a level across the length of the rod. Starting from the left side thread one ring through the holes of both the curtain and the liner. Once level have an assistant mark where the rod intersects the other wall.

Install your brackets using these marks for a level rod. Hold it while you level the rod. Using the hardware that is incl. For rods 84 and longer assemble with the connector piece.

Gently tap the anchors into the pilot holes with a hammer. Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1. Attach the rod and brackets to the wall with the mounting hardware provided. Continue threading until all 12 rings have been threaded through all 12 holes.

The method may vary by manufacturer. Lay the rod sections on the floor. 6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c. Drill pilot holes for the wall anchors.

Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall. How to install spring loaded shower curtain rods. Thread the shower curtain hooks rings through the curtain and liner. Spring loaded or spring tension shower curtain rods are a quick solution to getting your shower splash under control or brushing up a less than.

Install the first bracket by screwing it into place. 7 slide the 2nd wall plate into the rod as shown below see figure d. If there is a stud in your mounting location use wood screws to attach the wall brackets. Straight double shower curtain rod installation 5.

Verify that the rod sections are the proper length for your installation. Then move on to the next hole repeating the same process. Once you find the proper height level the shower rod. There should be no gap between the base of the wall plate and the end of the rod.

X pilot hole anchor.